Everything you need to know about Lighting for Ninebot Mini...
Everything you need to know about Lighting for Ninebot Mini...


Remove the pressure wire & Wire straps

Remove the wire harness strap,plug off the pressure wire from the controller board


Remove Front decorative lamp strip

Use Allen wrench_2.5mm dismount the four M3* screws to dismantle the strip. Pull the strip horizontally


Installation of the front lamp decorative strip

Install the front trim assembly, Plug in cables, and then install the front decorative strip. (Note: The cable and fastener)


Removal of rear light strip

Use Allen wrench _2.5mm dismount the four M3* screws to dismantle the strip. Pull the strip horizontally. Pull out the wire harness strip as shown in figure.


Installation of Rear light decorative strip

After installing decorative strip assembly, and then put the plastic wire harness. (Note: put the wire harness trim)